NanoVNA V2 50kHz-3GHz Vector Network Analyzer Antenna Analyzer VNA HF VHF UHF
Details
Feature:
1. Upgrade configuration: With our Seesii 3GHz vector network analyzer, you can test the standing wave impedance of the antenna, you can also debug the duplex, filter insertion loss, isolation, standing wave, and you can also test the cable attenuation, To shorten the coefficient and phase, you can also test the antenna amplifier amplification.
2. Powerful frequency meter: Improved frequency measurement can measure antenna frequencies from 2.4G to 3G. 70dB (50KHz-1.5GHz), 60dB (1.5GHz-3GHz). Reflection measurement S11: 50dB (50KHz-1.5GHz), 40dB (1.5GHz-3GHz); antenna analyzer: 1.005 (50KHz-1.5GHz), 1.02 (1.5GHz-3GHz)
3.The S-A-A-2/NanoVNA_V2 uses a similar user interface to the NanoVNA, but with a different technical architecture, the S-A-A-2/NanoVNA_V2 does not load the initial calibration data at startup, and does not automatically interpolate the calibration data after the user changes the frequency, and must recalibrate or call back the calibration data after each startup and frequency change. Please read the user manual carefully before use to avoid damaging the device..
4. Powerful and safe power supply: This SAA-V2 is battery-powered or USB-powered; built-in 1950 mAh battery, can work continuously for 6-8 hours, if you need extra working time, you can connect to a mobile power supply or power supply.
5. Compatibility: The 3GHz second-generation NanoVNA vector network analyzer is based on OwOComm's S-A-2 design, and its performance is greatly upgraded. Can be controlled by computer, compatible with Linux, Windows (7) computer software for control
Specification:
Frequency range: 50kHz - 3GHz
System dynamic range (calibrated): 70dB (up to 1.5GHz), 60dB (up to 3GHz)
S11 noise floor (calibrated): -50dB (up to 1.5GHz), -40dB (up to 3GHz)
Sweep rate: 100 points/s
Display: 2.8'', 320 x 240
USB interface: Micro USB
Power: USB, Maximum charge current 1A
Battery: 1950mAh lithium-ion
Battery connector: JST-XH 2.54mm
Maximum sweep points (on device): 201
Maximum sweep points (USB): 1024
Port 2 return loss (1.5GHz): 20dB typ
Port 2 return loss (3GHz): 13dB min
VNA-QT software supported platforms: Linux, Windows (7+), M ac OS planned
Weight: 246g
Packing size: 21*12*5cm
Packing list:
S-A-A-2 host (with 1950mAh battery) x 1
Micro USB data cable x1
30cm SMA male to male SS405 RF cable x2
SMA male calibration kit - OPEN x1
SMA male calibration kit - SHORT x1
SMA male calibration kit - LOAD x1
SMA female to female connector x1
Note:
1.Please kindly confirm the model of your car before ordering to make sure this item is perfect apply.
2.Due to the light and screen difference, the item's color may be slightly different from the pictures.
Ezonetronics RM - CT0008 7 inch 1 Din Re...
